The ability to change material properties between load steps during analysis (MPCHG command) can be easily set up in Mechanical.

From the results of two modal analyses, a MAC (Modal Assurance Criterion) value representing the correlation between modes is calculated, and you can view the results on Workbench.

With this extension, it is possible to simulate the phenomenon of heat source movement such as arc welding.

Evaluate anisotropic material constants for non-homogeneous material which is Lattice structure, Composite (e.g. FRP using short or long fiber), Honeycomb and so on. Template function to create microstructure model is also included in Design Modeler and SpaceClaim

Multiscale.Sim can perform multiscale analysis based on homogenization theory. You can observe macroscopic material responses and identify an-isotropic material constants by carrying out a Virtual Material Test using unit cell modeling of microstructure. Template to create the model is also included.

Provide a dialog box with view controls for the Mechanical graphics window. The controls allow for Pan, Zoom and Rotate in a style similar to the controls available in the Mechanical APDL interface

With this extension, the Ansys temperature sensor function (COMBIN37 element for turning on/off incoming heat) can be easily configured on Mechanical.

This tool allows you to create vertices on a geometry surface by entering the coordinates of the point where you want to create the vertex.